as far as sheet metal processing is concerned, its production and processing steps are to cause plastic deformation of some sheet metal parts according to manual manufacturing or stamping dies to make them into required shapes and specifications, and to further produce more complicated parts according to electric welding or a little mechanical processing. So how can everyone improve this technology? Let’s take a look together.

1. Standard principles for sheet metal processing should be standardized.

(sheet metal processing of chassis cabinet) special tools, tooling fixtures and product workpieces cannot be put into the top of the numerical control lathe and the top of its transmission. The concept must be centralized in the process of operation. Can not be tired, small talk, many people and their smoking manipulation.

In order to better prevent crumbled chips from encountering people, a fully transparent partition must be pressed in the appropriate area.

Strip chips and sheet metal processing long chips that occur during drilling must be treated with hooks as soon as possible and cannot be pulled by hand.

2. Strengthen scientific research on sheet metal processing technology.

scientific research on the change standard of strain force and size of prefabricated components in the plastic forming process of sheet metal processing, and selection of appropriate embryo and reasonable core embryo appearance, so as to reach the required appearance of prefabricated components.

scientific research on the interference of sheet metal processing standards such as temperature and strain rate utility on the plasticity production and processing resistance of metal materials and the methods of developing patience and reducing resistance of metal materials to obtain prefabricated components with excellent functions.

3. Do a good job in cleaning up and solving sheet metal processing.

The surface of the sheet metal must first be washed with water to eliminate waste from the surface.

Then scrub with soap, liquid detergent, or 5% ammonia in water.

Carefully wash with water again.

we wipe the water traces remaining on the surface of the cabinet. in the whole process of wiping, in order to scrub better and cleaner, we should scrub in the same direction. after scrubbing, we can let the surface dry naturally.