the precision processing sheet metal processing factory is beneficial to the feeding forming machine. in view of the current confusion of random injury, the following plan is clearly pointed out. its part-time table is equipped with guide rails, and the anchor screws on one side of the part-time table will not change the continuous motor, the coupling at the output end of the motor will not change the twisted flower rod that continuously rotates with the part-time table. The twisted flower rod spiral transmission cooperates with the roller that continuously overturns with the guide groove. The reasonable layout is simple, the application is convenient, and the hardware forming can be held well. In addition, the overlapping part-time work of machinery and equipment reduces the application of human resources, improves compliance. In addition, there are fewer mistakes, reduces employee injuries, and through waste Internet technology, guard part-time situation, suitable for production and processing.

cutting weapons and equipment with recuperation and clamping effect in precision processing sheet metal processing plant, cutting weapons and equipment with recuperation and clamping effect in precision processing sheet metal processing plant, base, unchanged column and clamping mechanism, both sides of the base are equipped with unchanged column, cast-in-place floor slab is installed in the middle of the upper side of the column, the right side of the bottom end of the cast-in-place slab is equipped with a boom, the lower side of the boom is equipped with a micro-crane, the left side of the micro-crane is equipped with a placement plate, the left side of the placement plate is equipped with a shaft seat, the left side of the placement plate is equipped with a shaft, the left side of the motor shaft is equipped with a cutting blade. When applying, place the object to be cut in the middle of the clamping jaw. Because of the advantages of torsion spring, the placement seat excites the coupling to turn over to both sides, so that the clamping jaw clamps the object to be cut. The ground anti-skid treatment layer is equipped to make the object to be cut difficult to turn over and double the whole cutting process.